Brick Pointing Techniques For New and Aged Brickwork

Brick Pointing Techniques For New and Aged Brickwork

Blog Article

Brick pointing is the strategy of applying a small level of mortar in the deal with joint concerning bricks. These bricks can either be newly laid ones or outdated brickwork. In new brickwork, pointing is done to apply more difficult mortar to enhance climate safety to the uncovered faces. In old brickwork, the tactic is used to restore the mortar joints which were eroded by publicity to various components.

For laying new and outdated brickwork, there are several strategies that have to be adopted in order to do the job appropriately.

On new brickwork, brick pointing need to be accomplished at practical intervals. Breaks at effortless points should be held to allow plenty of time for cleansing out the area mortar from the area. The mortar while in the joints really should be scraped to the depth of about 12 mm in the brick surface area. A wall can only be pointed when it has been concluded.

Concerning aged brickwork, the important Stucco contractor brick pointing methods involve chipping out the old mortar and pointing it to some correct depth. The common depth is twelve mm with the brick area. In removing the old mortar, angle grinders tend to be employed. Just take Notice that the procedure will bring about loads of dust, so you better put on encounter mask and goggles as you need to do The task.

After the wall is ready to be pointed, the brick pointing tactics for that mortar follows. Be certain that the joints are wetted to start with right before being filled with the pointing mortar.

Make a fairly stiff mix of the mortar and put a small amount on a hawk. In cutting off slithers of mortar, a small pointing trowel can be used. Hold the mortar up on the sting of the trowel and push it into your joints to generally be filled. Then, meticulously attract the blade backwards. Repeat the techniques until eventually the mortar is flushed Along with the deal with with the bricks.

Do the brick pointing approaches by filling the vertical cross-joints very first, accompanied by the horizontal mattress-joints. When much more than a square meter has been loaded, finish it utilizing the necessary style.

Report this page